Host Port Settings; Table 4-3. Host Port Settings - Advanced Energy HFV 8000 User Manual

Table 4-2. Host port connector (Continued)
Pin
8
9

Host Port Settings

An 8-position DIP switch determines the device ID (network address) and
communications baud rate.
To access the DIP switch:
1. Use a screwdriver to remove the two screws from the rear panel access cover (see
Figure 5-2 on page
2. Remove the rear panel access cover. The Host port connector and an 8-position
DIP switch are directly behind the cover.
Up to 31 device addresses are available (address 0 is reserved for broadcast
commands). A switch in the OPEN or OFF position represents a binary 1 for address
selection purposes.
baud rate selections.

Table 4-3. Host port settings

Switch Switch Switch
1 2 3
A4 A3 A2
Host
Port
- - - - - - - - - - - -
Address
MSB
Note 1
Requires internal modification to the unit. Contact Global Customer Support before removing
the safety cover (see
5705211-C
Name
RESERVED Reserved for future use
RESERVED Reserved for future use
5-4).
Table 4-3 lists the switch designations, and
Switch Switch
4 5
A1 A0
Host
Port
- - - - - -
Address
LSB
"AE Global Customer Support" on page 6-10
Communication Interfaces
HFV 8000 Generator
Description
Table 4-4
Switch Switch
6 7
BR1 BR0
Baud Baud
Rate Rate
Selection Selection
MSB LSB
).
lists the
Switch
8
Open for RS-
232
Closed for RS-
Note 1
485/422
4-11