Connecting Output Power; Connecting Input Power - Advanced Energy HFV 8000 User Manual

Connecting Output Power

Remove and lockout/tagout the input power before working on or around
the output terminals. Failure to do so could result in death or bodily
injury.
Complete the following steps to connect the output power connector:
1. Remove the two screws holding the output safety connector cover, and remove the
cover.
2. Slide the connector cover on the power cable.
3. Install the output cable on the output connector of the HFV generator.
4. Replace the output safety connector cover on the generator and fasten with screws
and star washers.
Note: The screws and star washers must be securely installed to prevent
excessive RF emissions and electrical shock.

Connecting Input Power

Before making any input line power connection, turn off and lockout/
tagout building circuit breakers supplying input power to the HFV
generator. Also, ensure that the circuit breakers on the rear panel are in
the OFF position.
5705211-C Installation, Setup, and Operation
HFV 8000 Generator
5-7