Motherboard Installation Example; Figure 4-16: Heat Sink Retention Screws; Figure 4-17: Motherboard Installation Example - IEI Technology WAFER-ULT5 Manual

Hide thumbs Also See for WAFER-ULT5:

Table of Contents

WAFER-ULT5 SBC

If the WAFER-ULT5 must be removed from the heat spreader, the five retention screws

must be removed.

Figure 4-11: Heat Sink Retention Screws

4.7.2 Motherboard Installation Example

Each side of the heat spreader has several screw holes allowing the WAFER-ULT5 to be

mounted into a chassis or a heat sink enclosure (please refer to Figure 1-3 for the detailed

dimensions). The user has to design or select a chassis or a heat sink enclosure that has

screw holes matching up with the holes on the heat spreader for installing the

WAFER-ULT5. The following diagram shows an example of motherboard installation.

Figure 4-12: Motherboard Installation Example

Page 53

Table of Contents