Internal Peripheral Device Connections; At Power Connection; Figure 4-18: Power Cable To Motherboard Connection - IEI Technology WAFER-ULT5 Manual

4.8 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the on-board connectors

4.8.1 AT Power Connection

Follow the instructions below to connect the WAFER-ULT5 to an AT power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the WAFER-ULT5.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 2.
Step 2: Connect the power cable to the motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the power connector on the motherboard. See
Figure 4-13.
Figure 4-13: Power Cable to Motherboard Connection
Page 54
WAFER-ULT5 SBC