Lcd Voltage Selection; Figure 4-14: Lcd Voltage Selection Jumper Location; Table 4-4: Lcd Voltage Selection Jumper Settings - IEI Technology WAFER-ULT5 Manual

Hide thumbs Also See for WAFER-ULT5:

Table of Contents

WAFER-ULT5 SBC

Step 4:

Restart the system. The system will reboot 2 ~ 3 times to complete the ME

firmware

update.Step 0:

4.6.4 LCD Voltage Selection

WARNING:

Incorrect voltages can destroy the LCD panel. Make sure to select a

voltage that matches the voltage required by the LCD panel.

CN Label:

CN Type:

CN Location:

CN Settings:

The LCD voltage selection jumper sets the voltage of the power supplied to the LCD

panel.

Setting

Short 1-2

Short 2-3

Table 4-2: LCD Voltage Selection Jumper Settings

Figure 4-10: LCD Voltage Selection Jumper Location

JP1

3-pin header, p=1.27 mm

See Figure 4-10

See Table 4-2

Description

+3.3 V (Default)

+5.0 V

Page 51

Table of Contents