Battery Connector; Figure 3-3: Battery Connector Location - IEI Technology WAFER-ULT5 Manual

WAFER-ULT5 SBC

3.2.2 Battery Connector

CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Only
certified engineers should replace the on-board battery.
Dispose of used batteries according to instructions and local
regulations.
NOTE:
It is recommended to attach the RTC battery onto the system chassis
in which the WAFER-ULT5 is installed.
CN Label:
CN Type:
CN Location:
CN Pinouts:
The battery connector is connected to the system battery. The battery provides power to
the system clock to retain the time when power is turned off.

Figure 3-3: Battery Connector Location

BAT1
2-pin wafer, p=1.25 mm
See Figure 3-3
See Table 3-4
Page 17