Internal Peripheral Device Connections; Keyboard/Mouse Y-Cable Connector - IEI Technology PM-PV-N4551/D5251 User Manual

NOTE:
IEI has a wide range of backplanes available. Please contact your
vendor, reseller or an IEI sales representative at
or visit the IEI website (http://www.ieiworld.com) to find out more about
the available chassis.

4.8 Internal Peripheral Device Connections

This section describes the installation of various peripheral connectors available for the
PM-PV-N4551/D5251.

4.8.1 Keyboard/Mouse Y-cable Connector

The PM-PV-N4551/D5251 is shipped with a keyboard/mouse Y-cable connector. The
keyboard/mouse Y-cable connector connects to a keyboard/mouse connector on the
PM-PV-N4551/D5251 and branches into two cables that are each connected to a PS/2
connector, one for a mouse and one for a keyboard. To connect the keyboard/mouse
Y-cable connector, please follow the steps below.
Step 1: Locate the connector. The location of the keyboard/mouse Y-cable connector is
shown in Section 3.1.1.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the PM-PV-N4551/D5251 keyboard/mouse connector. See Figure 4-9.
Step 3: Insert the cable
the keyboard/mouse connector on the PM-PV-N4551/D5251, connect the cable
connector to the onboard connectors. See Figure 4-9.
Page 48
PM-PV-N4551/D5251 User Manual
connectors. Once the cable connector is properly aligned with
sales@ieiworld.com