Internal Peripheral Device Connections; Figure 4-18: Msata Setup Jumper Location - IEI Technology AESQ170-969 User Manual

Figure 4-18: mSATA Setup Jumper Location

4.10 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard
connectors.
4.10.1 SATA Drive Connection
The AESQ170-969 is shipped with two SATA drive cables. To connect the
SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive
connectors are shown in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-
board SATA drive connector until it clips into place. See Figure 4-19.
Chapter 4
67
Installation