Internal Peripheral Device Connections; At Power Connection; Figure 4-10: Power Cable To Motherboard Connection - IEI Technology NANO-QM770-R10 User Manual

4.7 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.7.1 AT Power Connection

Follow the instructions below to connect the NANO-QM770 to an AT power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the NANO-QM770.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 2.
Step 2: Connect the Power Cable to the Motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the AT power connector on the motherboard. See
Figure 4-10.

Figure 4-10: Power Cable to Motherboard Connection

Page 52
NANO-QM770 EPIC SBC