Swing Beam Assembly - KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual

Step 29: Swing Beam Assembly
Part 1
A: Attach 6 Swing Hangers to the (9452) Engineered Beam using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with 2 flat
washers and 1 lock nut) per Swing Hanger as shown in fig. 29.1 .
B: Install 1 (WB7) 5/16 x 3" Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (9452) Engineered
Beam as shown in (fig. 29.2). IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE
CHECKING OF WOOD.
C: Attach KidKraft Plaque to centre of (9452) Engineered Beam (over top of t-nut) using 4 (S18) #6 x 1" Wood
Screws. (fig. 29.3)
Fig. 29.1
Fort End
Swing Hanger x 6
Fig. 29.2
FW2
WB7
Wood Parts
1 x Engineered Beam 3 x 5-1/4 x 88"
9452
9452
TN2
9452
Hardware
12 x 5/16 x 5-1/2" Hex Bolt
G7
(FW2 x 2, LN2)
1 x 5/16 x 3" Wafer Bolt
WB7
(FW2 & TN2)
4 x #6 x 1" Wood Screw
S18
G7
Fig. 29.3
KidKraft
Plaque
72
LN2
FW2
FW2
x 4
S18
Other Parts
6 x Swing Hangers
1 x KidKraft Plaque