KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual page 29

Step 4: Swing Wall Assembly
A: With a helper, stand Front Wall Panel upright and place (9213) SW Wall Panel against the tall end of the
panel so that the edges are flush. The bottom of the panels should be flush and panels square. Pre-drill with a
3/16" drill bit, then fasten (9213) SW Wall Panel to Front Wall Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig.
4 .1)
B: Repeat Step A to install (9213) SW Wall Panel to the Back Wall Panel .
Fig. 4.1
WL5
WL5
9213
Flush
Wood Parts
Hardware
1 x SW Wall Panel 1-1/4 x 37 x 92"
9213
8 x 1/4 x 2-1/2" Wafer Lag
WL5
29