KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual page 73

Step 29: Swing Beam Assembly
Part 2
D: On the Fort End of (9452) Engineered SW Beam attach 2 Heavy Flat Brackets with 2 (G21) 5/16 x 3-3/4"
Hex Bolts (with 2 flat washers and 1 lock nut). (fig. 29.4 & 29.5)
E: Place (9352) SW Mount in between both Heavy Flat Brackets . Attach (9352) SW Mount to Heavy Flat
Brackets with 2 (G21) 5/16 x 3-3/4" Hex Bolts (with 2 flat washers and 1 lock nut) (fig 29.4). Install a 5/16" t-nut
into the bottom pre-drilled hole in the (9352) SW Mount as shown in fig. 29.6.
F: Place 1 Heavy L-Bracket against (9452) Engineered SW Beam and (9352) SW Mount . Attach with 1 (G17)
3/8 x 6" Hex Bolt (with 2 flat washers and lock nut) and 1 (G10) 5/16 x 3" Hex Bolt (with lock washer, flat
washer and t-nut). (fig 29.7)
Fig. 29.4
LN2
FW2
FW2
Note: It is important to note
hole orientation for this step.
Fig. 29.6
TN2
Wood Parts
1 x SW Mount 3 x 3 x 16"
9352
9352
Heavy Flat
Bracket
G21
Hardware
G21
4 x 5/16 x 3-3/4" Hex Bolt (FW2 x 2, LN2)
1 x 3/8 x 6" Hex Bolt (FW10 x 2 & LN3)
G17
1 x 5/16 x 3" Hex Bolt (LW2, FW2, TN2)
G10
1 x
TN2
Fort End
9452
Fig. 29.7
LW2
FW2
TN2
Heavy
L-Bracket
G17
73
Fig. 29.5
LN3
FW10
G10
FW10
Other Parts
2 x Heavy Flat Bracket
1 x Heavy L-Bracket