Table of Contents
Advertisement
Step 46: Attach TNR 4 Clamp Rings
A: Place 2 TNR4 Clamp Rings around each joint making sure to match the arrows with the end of the Clamp
Ring as shown in (fig. 46.1 & 46.2 ).
B: Connect TNR4 Clamp Rings in 2 spots using 1 (PB6) ¼ x 1" Pan Bolt (with lock nut) per side. (fig. 46.3)
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess.
Fig. 46.1
TNR4
Clamp
Rings
TNR4
Clamp
Rings
Note: For ease of
assembly bottom
set of clamp rings
can be rotated 90
degrees to install
bolts .
Fig. 46.2
PB6
After the clamp rings are attached to
the elbows, fasten them end to end
with two pan bolts and lock nuts
Hardware
10 x
1/4 x 1" Pan Bolt (LN1)
PB6
92
PB6
LN1
Make sure arrows
are aligned
Fig. 46.3
LN1
Other Parts
10 x TNR4 Clamp Ring
Advertisement
Table of Contents
