Table of Contents
Advertisement
Step 49: Attach Elbow Assemblies and TNR4 Slide
A: Place TNR Brace assembly centered over pilot holes of (8963) TNR Ground Brace . Attach with 2 (S3) #8 x
2-1/2" Wood Screws. (fig. 49.1 & 49.3)
B: Place 1 TNR4 Post Mount Clamp on either side of the Clamp Ring so that the bent tops clip in behind the
Clamp Ring. (fig. 49.2)
C: Insert the TNR4 Post Mount Base in between the 2 Post Mount Clamps and screw all pieces together using 1
¼ x 14.5mm Pan Head Bolt and Square Nylock Nut. (fig. 49.2)
D: Attach TNR4 Post Mount Base to (8965) TNR Upright, pre-drill with a 1/8" drill bit then attach with 2 (S6) #12 x
1" Pan Screws. (fig. 49.2)
E: Attach the Post Mount Clamp to the clamp ring using 1 (S37) #7 x 5/8" Pan Screw. (fig. 49.2)
Fig. 49.1
9214
9363
Fig. 49.2
¼ x 14 .5mm
Pan Head Bolt
TNR4 Post
Mount Base
S6
Fig. 49.3
S3
Hardware
2 x
#12 x 1" Pan Screw
S6
2 x
#8 x 2-1/2" Wood Screw
S3
1 x
#7 x 5/8" Pan Screw
S37
95
TNR4 Post
Mount Clamp
S37
100
Other Parts
2 x TNR4 Post Mount Clamp
1 x TNR 4 Post Mount Base
1 x 1/4 x 14.5 mm Pan Head Bolt
1 x Square Lock Nut
Square
Lock
Nut
8965
8963
Advertisement
Table of Contents
