KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual page 24

Step 3: Back Wall Assembly
Part 1
Note: All bolts are installed loosely from the underside of panel assembly.
A: On the ground lay flat (9370) Right Upright Back and to the right of it lay flat (9371) Left Upright Back, making
sure that the notches on both boards are facing up and that they are oriented as shown in fig. 3.1. Place (9365) TB
Support across the top of the Uprights so that it fits into the notches and the edges are flush as shown in fig. 3.1.
Attach (9365) TB Support to each Upright using 1 (WB1) 5/16 x 1" Wafer Bolt (with flat washer and t-nut) per side.
(fig. 3.1)
B: Place (9364) Center Upright under the pre-drilled center hole in (9365) TB Support and attach using 1 (WB1)
5/16 x 1" Wafer Bolt (with flat washer and t-nut). (fig. 3.1)
C: Lay flat (9376) Back Post Right and to the right side of it lay flat (9360) Back Post Left, making sure that the
notches on both boards are facing up and that they are oriented as shown in fig. 3.2. Place (9372) Cross Frame
across the bottom of the Posts as shown in fig. 3.2 and attach each side using 1 (WB1) 5/16 x 1" Wafer Bolt (with
flat washer and t-nut). (fig. 3.2)
D: Place 1 (9362) Cross Support Middle so that it fits into the center notches of each Post taking note of the hole
orientation . Attach (9362) Cross Support Middle to (9360) Back Post Left using 1 (WB1) 5/16 x 1" Wafer Bolt (with
flat washer and t-nut). (fig. 3.2)
Fig. 3.1
9370
Fig. 3.2
Wood Parts
1 x Back Post Left 1-1/4 x 3 x 89"
9360
1 x Cross Support - Middle 1-1/4 x 3 x 41-7/16"
9362
1 x Back Post Right 1-1/4 x 3 x 92"
9376
1 x Center Upright 1-1/4 x 3 x 58-1/2"
9364
1 x TB Support 1-1/4 x 2-1/2 x 42-15/16"
9365
9365
9364
9371
TN2
FW2
WB1 x 3
1 x Right Upright Back 1-1/4 x 3 x 16-1/2"
9370
1 x Left Upright Back 1-1/4 x 3 x 22-1/2"
9371
1 x Cross Frame 1-1/4 x 3 x 62-1/4"
9372
TN2
FW2
x 3
WB1
9376
9362
9372
9360
24
Hardware
6 x 5/16 x 1" Wafer Bolt
WB1
(FW2, TN2)