Table of Contents
Advertisement
Step 51: Install Ground Stakes
A: In the 6 places shown in fig. 51.1 drive the Rebar Ground Stakes 13" (33cm) into the ground against (2606)
SW Ground, (9214) End Slide Panel, (9239) Left Rail, both (2613) SW Posts and (8965 ) TNR Upright . Be careful
not to hit the washer while hammering stakes into the ground as this could cause the washer to break off. (fig.
51 .1 and 51 .2)
B: Attach Ground Stakes using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 51.3.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer . Smooth any
sharp edges from impact area and touch up with outdoor paint .
must be driven 13" (33cm) into ground. Digging or driving stakes can be
dangerous if you do not check first for under-ground wiring, cables or
gas lines.
Fig. 51.1
8965
9214
SEE FRONT COVER
FOR SAFETY CLEARANCE
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes
9239
2606
2613
2613
Hardware
6 x
Pan Screw
S7
97
Fig. 51.2
Fig. 51.3
S7
Rebar
Ground
Stake
Other Parts
6 x Rebar Ground Stake
9214
S7
Rebar
Ground
Stake
8965
Advertisement
Table of Contents
