Table of Contents
Advertisement
Step 50: Attach TNR 3 Slide to Fort
A: On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the fort (installed in Step 40) .
(fig. 50.1) The bolt will no longer be needed, but keep the lock nut.
B: Loosely attach TNR3 Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1" Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 50.2)
C: Rotate TNR3 Tube Support and attach to (9214) End Slide Panel using 1 (S6) #12 x 1" Pan Screw as shown in (fig.
50 .2) .
D: Fully tighten screw and bolt .
Fig. 50.2
TNR 3 Tube
Support
9214
Note: Flat
end down
LN1
S6
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
1 x
#12 x 1" Pan Screw
S6
1 x
1/4 x 1" Pan Bolt
PB6
(FW1 & LN1 - previously removed)
Fig. 50.1
FW1
PB6
Hardware
96
9214
Other Parts
1 x TNR3 Tube Support
A
Advertisement
Table of Contents
