Step 30: Swing End Assembly
A: Loosely attach 2 (2613) Heavy SW Posts to (2615) SW Upright using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with
lock washer, flat washer and t-nut). Notice 2 bolt holes at top of (2615) SW Upright and orientation of angle.
(fig. 30.1)
B: Attach (2616) SW Support to both (2613) Heavy SW Posts and (2615) SW Upright using 3 (G4) 5/16 x 4"
Hex Bolts (with lock washer, flat washer and t-nut). Tighten all bolts. (fig. 30.1)
C: Install 2 (WB7) 5/16 x 3" Wafer Bolts (with flat washer and t-nut) in the top bolt holes in (2615) SW Upright
as shown in fig. 30.1. IT IS IMPORTA NT THAT THESE BOLTS ARE ATTACHED. THEY WILL MINIMIZE
CHECKING OF WOOD.
Fig. 30.1
2613
Wood Parts
2 x
Heavy SW Post 2 x 3 x 86-11/16"
2613
1 x
SW Upright 3 x 3 x 50-15/16"
2615
1 x
SW Support 15/16 x 3-1/4 x 46-1/2"
2616
2616
TN2
FW2
LW2
G4
2 x
Hex Bolt 5/16 x 5-1/2" (LW2, FW2, TN2)
G7
3 x
Hex Bolt 5/16 x 4" (LW2, FW2, TN2)
G4
2 x
Wafer Head Bolt 5/16 x 3" (FW2 & TN2)
WB7
TN2
2615
Hardware
74
FW2
WB7
G7
FW2
LW2
Notice 2 bolt
holes at top and
orientation of
the angle
TN2