Table of Contents
Advertisement
Step 2: Front Wall Assembly
Part 1
Note: All bolts are installed loosely from the underside of panel assembly.
A: On the ground lay flat (9368) Right Upright Front and to the right of it lay flat (9369) Left Upright Front, making
sure that the notches on both boards are facing up and that they are oriented as shown in fig. 2.1. Place (9365) TB
Support across the top of the Uprights so that it fits into the notches and the edges are flush as shown in fig. 2.1.
Attach (9365) TB Support to each Upright using 1 (WB1) 5/16 x 1" Wafer Bolt (with flat washer and t-nut) per side.
B: Place (9364) Center Upright under the pre-drilled center hole in (9365) TB Support and attach using 1 (WB1)
5/16 x 1" Wafer Bolt (with flat washer and t-nut). (fig. 2.1)
C: Lay flat (9375) Front Post Right and to the right side of it lay flat (9361) Front Post Left, making sure that the
notches on both boards are facing up and that they are oriented as shown in fig. 2.2. Place (9372) Cross Frame
across the bottom of the Posts as shown in fig. 2.2 and attach each side using 1 (WB1) 5/16 x 1" Wafer Bolt (with
flat washer and t-nut).
D: Place 1 (9362) Cross Support Middle so that it fits into the center notches of each Post taking note of the hole
orientation . Attach (9362) Cross Support Middle to (9375) Front Post Right using 1 (WB1) 5/16 x 1" Wafer Bolt
(with flat washer and t-nut). (fig. 2.2)
Fig. 2.1
9368
9364
Wood Parts
1 x
Cross Support - Middle 1-1/4 x 3 x 41-7/16"
9362
1 x
TB Support 1-1/4 x 2-1/2 x 42-15/16"
9365
1 x
Cross Frame 1-1/4 x 3 x 62-1/4"
9372
1 x
Front Post Right 1-1/4 x 3 x 89"
9375
9365
9369
TN2
Fig. 2.2
FW2
x 3
WB1
1 x
Front Post Left 1-1/4 x 3 x 92"
9361
1 x
Right Upright Front 1-1/4 x 3 x 22-1/2"
9368
1 x
Left Upright Front 1-1/4 x 3 x 16-1/2"
9369
1 x
Center Upright 1-1/4 x 3 x 58-1/2"
9364
TN2
FW2
x 3
WB1
9362
9375
9372
19
9361
Hardware
6 x
5/16 x 1" Wafer Bolt
WB1
(FW2, TN2)
Advertisement
Table of Contents
