Attach Tnr 3 Slide Exit To Elbow Assembly - KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual

Step 44: Attach TNR 3 Slide Exit to Elbow Assembly
A: Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR3 Short Exit. (fig. 44.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4
x 3/4" Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (fig. 44.2 and 44.3)
C: At this point make sure all the slide bolts are tight .
Use a 7/16" open end wrench to hold nut and then tighten bolt with Quadrex Driver.
Fig. 44.1
TNR3
Short Exit
Exit Elbow
Assembly
Slot of TNR3
Short Exit
LN1
Fig. 44.3
PB1
5 x
PB1
Start with
this bolt
Hardware
1/4 x 3/4" Pan Bolt (LN1)
PB1
90
Fig. 44.2
LN1
Bottom of Slide Views
Other Parts
1 x TNR3 Short Exit
PB1