Attach Diagonal - KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual

Step 33: Attach Diagonal
A: Loosely attach (2606) SW Ground to (2607) Diagonal with 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock washer,
flat washer and t-nut) (fig.33.2) then place (2607) Diagonal tight and flush to the front of (9213) SW Wall Panel.
(2606) SW Ground to be flush to the bottom of (9213) SW Wall Panel. (fig. 33.1 and 33.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (2607) Diagonal to (9213) SW Wall Panel with 1 (WL5) 1/4
x 2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 33.2)
C: Make sure bottom of (2606) SW Ground is flush to bottom of (9213) SW Wall Panel then attach with 2 (S11)
#8 x 2" Wood Screws and 1 (S3) #8 x 2-1/2" Wood Screw then tighten the bolt. (fig. 33.2)
Fig. 33.1
2607
2606
Wood Parts
1 x SW Ground 15/16 x 3-1/4 x 14-1/4"
2606
1 x Diagonal 1-1/4 x 3 x 22"
2607
9213
2607
TN1
17
Hardware
1 x 1/4 x 2-1/4" Hex Bolt (LW1, FW1, TN1)
H10
1 x 1/4 x 2-1/2" Wafer Lag (FW2)
WL5
1 x #8 x 2-1/2" Wood Screw
S3
2 x #8 x 2" Wood Screw
S11
77
Fig. 33.2
FW2
WL5
2606
H10
FW1
LW1
9213
Tight and
flush to
outside
edge
S11
S3