KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual page 68

Step 27: Attach Roof Panels
Part 1
Note: It is important to ensure that there is a 5mm square opening in the top, center of the roof. This will
be used in a later step.
Build 4 of these assemblies
A: Bend roof panel along the fold to allow the panel to fit between the gables. (fig. 27.2)
B: Place panel onto the gable as shown in fig. 27.2, making sure that it's flush to the end and side edge of the
(2852) Roof End. (fig. 27.1 and 27.4)
C: Attach the roof panel to (2852) Roof End using 3 (S11) #8 x 2" Wood Screws per side. (fig. 27.2 and 27.3)
Build 4 of these assemblies
Fig. 27.1
Flush
2852
Fig. 27.3
2852
Build 4 of these assemblies
Fig. 27.2
S11
x 3
Fig. 27.4
Hardware
3 x #8 x 2" Wood Screw
S11
68
3X #8 x 2 WS
3X #8 x 2 WS
2852
Flush to end of
Roof End
C
3X #8 x 2 WS
Roof
Panel
Bend Roof
Panels
Flush to side edge
of Roof End
A
Other Parts
1 x Roof Panel