KidKraft Cedar Summit DEVONSHIRE ELITE Installation And Operating Instructions Manual page 34

Step 7: Join Swing and Slide Assemblies
Part 2
C: From inside the assembly, tight to the Front Wall Panel, measure 5/8" (16mm) down from the center of the
panel assembly and loosely attach 1 (9356) Side Floor Joist to Front Wall Panel using 3 (WB10) 5/16 x 2-5/8"
Wafer Bolts (with flat washer and t-nut), making sure that it's tight to the (9214) End Slide Panel. Bolts are
installed from inside the assembly. (fig 7.2, 7.3, 7.4 and 7.5)
D: Place (9382) Side Joist so that it fits between the (9356) Side Floor Joist and (9213) SW Wall Panel and
loosely attach using 1 (WB10) 5/16 x 2-5/8" Wafer Bolt (with flat washer and t-nut). (fig 7.2, 7.3, 7.4 and 7.5)
E: Make sure (9356) Side Floor Joist and (9382) Side Joist are level then attach with 2 (S3) #8 x 2-1/2" Wood
Screws per joist and tighten bolts. (fig 7.2, 7.3 and 7.5)
F: Repeat Steps B - D to install (9356) Side Floor Joist and (9382) Side Joist to the Back Wall Panel .
Fig. 7.2
9002 9451
9214
Fig. 7.5
NOTE hole
orientation
Wood Parts
2 x Side Floor Joist 1-1/2 x 1-1/2 x 62-13/64"
9356
2 x Side Joist 1-1/2 x 1-1/2 x 21-15/32"
9382
NOTE: hole orientation
9362
9382
9356
front wall hidden
for clarity
front wall
hidden for
clarity
8 x
S3
8 x
WB10
S3
x 4 per
side
9213
Fig. 7.4
5/8" (16mm)
front wall
hidden for
clarity
S3
9356
WB10
Hardware
#8 x 2-1/2" Wood Screw
5/16 x 2-5/8" Wafer Bolt
(FW2, TN2)
34
Fig. 7.3
FW2
WB10
9356
x 4 per
side
or
9356 9382
9382
TN2
Panel