Slide Wall Assembly - KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual

Step 2: Slide Wall Assembly
A: Place (021) Narrow Back Panel against the left side of (022) Slide End Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(021) Narrow Back Panel to (022) Slide End Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 2.1 & 2.2)
B: Place (023) Narrow Front Panel against the right side of (022) Slide End Panel noticing panel orientation.
The tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(022) Slide End Panel to (023) Narrow Front Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 2.1 & 2.3)
Fig. 2.2
021
022
Notice (021) Narrow
Back Panel overlaps
(022) Slide End Panel
WL5
Wood Parts
1 x Slide End Panel 1-1/4 x 37 x 92"
022
1 x Narrow Back Panel 1-1/4 x 21-1/2 x 92"
021
1 x Narrow Front Panel 1-1/4 x 21-1/2 x 92"
023
Flush
Fig. 2.1
021
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
Fig. 2.3
022
023
Flush
20
Flush
023
022
Notice (022) Slide End
Panel overlaps (023)
Narrow Front Panel