Front Wall Assembly - KidKraft WINDALE Installation And Operating Instructions Manual

Step 9: Front Wall Assembly
A: With both the Front and Back Walls facing each other, on the side with longer extension of (1935) Side Roof,
loosely attach (2210) Front Back Ground to the (2215) Posts with 2 (H4) 1/4 x 4" Hex Bolts (with lock washer, flat
washer and t-nut). (fig. 9.1)
B: Approximately half way up the wall loosely attach (2212) Floor Front to both (2215) Posts with 2 (H4) 1/4 x 4"
Hex Bolts (with lock washer, flat washer and t-nut). The arch should be on the right side of the wall. (fig. 9.1)
C: Loosely attach (2213) Front Divider to (2210) Front Back Ground, (2212) Floor Front and (1906) Top Front
Back with 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer and t-nut) per board. (fig. 9.1)
D: Make sure (1906) Top Front
Back is level then attach to both
(2215) Posts using 4 (S7) #12
x 2" Pan Screws (with 3/16" flat
washers). (fig. 9.1)
E: Make sure the assembly is
square, then attach (2212) Floor
Front to the posts and (2213)
Front Divider with 3 (S7) #12 x
2" Pan Screws (with 3/16" flat
washers), as shown in fig. 9.1.
F: Tighten all bolts.
Wood Parts
1 x Front Back Ground 1 x 4 x 53"
2210
1 x Floor Front 1 x 5 x 38-1/2"
2212
1 x Front Divider 2 x 2 x 81"
2213
1 x Top Front Back 1 x 4 x 38-1/2"
1906
Assemble Front Wall
Notice longer end.
1906
H2
2213
1/4" flat
washer
1/4" lock
washer
H4
1935
1/4"
t-nut
S7
with 3/16"
flat washer
2215
H2
Hardware
4 x H4 1/4 x 4" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
7 x #12 x 2 Pan Screw (3/16" flat washer)
S7
3 x 1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
H2
25
with 3/16"
S7
flat washer
x 4
S7
with 3/16"
flat washer
2215
H4
Fig. 9.1
1935
2212
2210