Connect The New Groups To The Fiber Network - Nortel MER-1002-003 Manual

Documentation Release Note

Connect the new groups to the Fiber Network

Nortel Networks
5 Define the loops in the new group.
For example:
LD 17
REQ
TYPE
....
XCT
....
6 Enable the new loops.
LD 34
ENLX
****
7 Wait for the FIJI card to enable. The time to enable will vary.
—————————— End of Procedure ——————————
CAUTION
Service Interruption
The Fiber Network Rings must be in Normal mode to
complete this procedure. Resolve any faults and restore
the Rings to Normal mode before Network Groups are
added.
Procedure 14
Connect new groups to the Fiber Network
1 In each new Network Group, connect a NTRC47AA cable from J4 to
J4 of the FIJI cards. See Figure 5.
to load the program
CHG
CEQU
xxx (enter the new loop)
xxx
to load the program
to enable the newly defined loop
to exit the program
11/4/02
Number: MER-1002-003
22 of 26
TM