GBC AdvancedPunch Technical & Service Manual page 91

Advanced Punch Service Manual
side). Start each screw to achieve proper alignment, then go back over each
screw and tighten it.
7. Install the Cable Guard on top of the Die Set storage rack (2 Screws).
8. Install the curved sheet metal Exit Paper Guide with Idler Roller 4 screws.
9. Start all 4 screws, (2 on front and 2 on back) then tighten.
10. Connect the sensor wire harness at the top rear of the Exit Paper Guide.
11. To install the Idler Aligner Paper Guide:
a. Hold it loosely in place.
b. Press the nylon flange bearings into place, through both pieces of sheet
metal, with the flange to the inside
c. Slide the shaft through the front of the machine, while holding the nylon
flange bearing in place.
d. Secure with 2 E-rings on the inside of the bearing.
e. Inspect by pressing in on the bottom area of the sheet metal for:
– A slight deflection of each Idler Roller as you press.
– As you press, you can turn the pulleys at the rear of the Advanced Punch and see
the Idler Rollers rotate smoothly.
12. Bend the small metal tab back into place.
13. Install the flipper shaft back into place by inserting it first into the front, then the
back.
14. Close the Flipper Latch.
Repeat the test of rotating the pulleys to ensure smooth rotation of the Idler
Rollers.
15. Attach the shaft spring.
16. Install the front E-Ring to secure flipper latch.
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
4-33