Door Latch Inspection; Separating Punch From Printer; Rear Cover Removal - GBC AdvancedPunch Technical & Service Manual

Section 1

1.4.7 Door Latch Inspection

1.4.8 Separating Punch From Printer

1.4.9 Rear Cover Removal

1-14
The door latch must hold the door closed and ensure that the switch activation tab
is depressing the door switch [1]. The switch tab [2] should press the switch button
just so that it is close to bottoming.
Maintenance Schedule
Inspect every 750K cycles.
Procedure
•
Ensure latch holds door closed.
•
Ensure switch is activated when the door is closed.
•
To adjust the door latch, see "Door Latch" on page 4-5.
[2]
Figure 1.10 Door Switch Tab and Switch.
Some procedures require separating the Advanced Punch from the printer and
finisher. Refer to "Separating the Punch From the Printer" on page 4-1.
Some procedures require the removal of the rear cover. Refer to "Removing the
Rear Cover" on page 4-2.
© Copyright 2009 GBC. All rights reserved.
[1]
Advanced Punch Service Manual