6.7 Tools
6.8 Lubrication
Advanced Punch Service Manual
Tools recommended for service of the GBC Advanced Punch:
Standard Measure Tools (English as opposed to metric)
•
Open end ignition wrench - 1/4" (required only for chad kit installation)
•
Phillips screwdriver or 1/4" (6.5 mm), 5/16" (8 mm) and 11/32" (9 mm) nut drivers
•
Hex wrenches, 3/32", 5/64", 9/64" and 0.050"
Other Recommended Tools and Supplies
•
Needle nose pliers
•
Wire cutters
•
Screw driver, flat head, small
•
Supply of wire tie wraps
•
Snap Ring pliers
GBC Supplied Tool Kit Part Number
•
600N03329 - TOOL KIT W/WRENCH
For General lubrication please see the following sections
•
1.3.4
Dieset pins-
•
Dieset shoulder bolts-
•
4.9.2
Punch Drive cam-
© Copyright 2009 GBC. All rights reserved.
1.3.4
General Procedures
6-9