External Cleaning; Internal Cleaning; Operational Inspection; Internal Inspection - GBC AdvancedPunch Technical & Service Manual

1.4.1 External Cleaning

1.4.2 Internal Cleaning

1.4.3 Operational Inspection

1.4.4 Internal Inspection

Advanced Punch Service Manual
The cover may be cleaned with a soft cloth moistened with mild detergent and
warm water.
Do not use chemical cleaners or solvents as these may have a harmful effect. Use
detergent sparingly to avoid contact with electrical components.
Warning: Make sure you disconnect the Advanced Punch from its power source
before cleaning. Failure to observe this warning could result in death or serious
Injury.
Occasionally remove the covers and remove paper dust and chips. Paper dust
can accumulate throughout the punch including around the motor and other
electrical components. Use a vacuum cleaner if possible. A small paintbrush can
also be used but extreme care should be used around electrical components.
Non-electrical components may be cleaned with alcohol, an approved cleaner, or
a soft cloth moistened with mild detergent and warm water. Rollers can be
cleaned with alcohol.
Warning: Make sure you disconnect the Advanced Punch from its power source
before cleaning. Failure to observe this warning could result in death or serious
Injury.
Make sure the punch operates smoothly and produces the desired holes in the
customer's paper.
Whenever the cover has been removed for corrective maintenance, visually
inspect for defects and problems such as damaged components, loose screws or
nuts, abraded wire insulation, loose terminals, etc. Correct any problems before
returning the machine to service.
© Copyright 2009 GBC. All rights reserved.
Maintenance
1-11