GBC AdvancedPunch Technical & Service Manual page 116

Section 4
4-58
7. Loosen the 2 clutch socket head set screws [1], slide the clutch [2] off the shaft,
and remove the shaft key [3].
[2]
[1]
[3]
Installation Note: When installing the clutch, be sure to install the shaft key.
Press the clutch against the drive gear plate. While pressing the clutch against the
plate, tighten the 2 set screws. The assembly does not require a gap between the
clutch and clutch plate.
8. Cut wire ties as needed and unplug the clutch connector [1] from the control
board.
Figure 4.66 Punch Clutch Connector on the Control Board.
© Copyright 2009 GBC. All rights reserved.
Figure 4.65 Punch Clutch.
Advanced Punch Service Manual
[1]