Rap Paper Jams At Punch, Chad Is Present In The Paper Path; Rap Description; Rap Initial Actions; Rap References - GBC AdvancedPunch Technical & Service Manual

2.4 RAP Paper Jams at Punch, Chad is Present in the
Paper Path

2.4.1 RAP Description

2.4.2 RAP Initial Actions

2.4.3 RAP References

2.4.4 RAP Procedure

Advanced Punch Service Manual
Yes : Replace the Main Control Board
No: Replace the J3 Cable
The system is frequently exhibiting paper jams in the Punch Die or just after the
sheets are punched.
Run several sheets to confirm the symptom.
Locate a different Die Set (any pattern).
Run several more sheets to confirm the symptom.
Die set maintenance section
1. Inspect the die set that results in frequent paper jams. The oil pad, pins or
shoulder bolt lubrication appears to be dried away.
Y- Perform the lubrication procedures explained in section
N- Go to the next step.
2. Inspect the die set shoulder bolts for straightness. One or both of the bolts are
bent.
Y-Replace the die set.
N- Go to the next step.
3. Inspect the die set pressure bar springs as shown in section 1.3.2.2 One of the
springs is missing.
Y-Replace the missing spring.
N-Replace the die set.
© Copyright 2009 GBC. All rights reserved.
Fault Analysis Procedures
1.3
1.3
2-5