Punch Module Motor Drive Belt Replacement - GBC AdvancedPunch Technical & Service Manual

4.9.5.1 Punch Module Motor Drive Belt Replacement

Advanced Punch Service Manual
Procedure
Replace the belt when it is frayed, missing teeth, or worn out.
To replace the Punch Module drive belts:
1. With the fan removed from the shaft, work the belt [1] off the clutch gear [2].
[1]
2. Install a new belt by looping it over the motor pulley and then work it onto the
clutch gear.
The belt requires no adjustment. It should have slight deflection when pressed.
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
Figure 4.74 Motor Pulley and Belt.
[2]
4-65