GBC AdvancedPunch Technical & Service Manual page 90

Section 4
PAPER ENTERANCE
SIDE
FRONT DOOR
SIDE
4-32
3. To install the Paper Guide assembly into the Advanced Punch:
ASSEMBLE BACK
Figure 4.32Installing the Paper Guide Assembly.
a. As you slide the Paper Guide assembly into place:
– Hook up the Sensor Harness to the Sensor on the back.
– Lift it up slightly to clear the lower Transition Paper Guide.
– Be sure to clear the sensor bracket at the top left.
– Be sure that the Flex Coupling shaft is sticking out of the rear of the Advanced
Punch properly.
b. Visually check all around the mounting area of the Paper Guide assembly
and that the sensor harness is properly connected.
c. Loosely secure it in place with 3 screws on the left and 3 on the right.
d. Loosely install the 2 top screws.
e. Once all 8 mounting screws have been properly started go back and tighten
the screws until they are snug.
Caution: Do not over tighten the 2 screws on top.
4. Install the 2 screws to secure the bearing block for the pulley arrangement at
the rear of the Advanced Punch. Press the block to the top of the punch before
tightening
5. Install the pulley and belt onto the pulley block. Once properly aligned, check
belt and pulley movement. Tighten the set screw.
6. Install the Die Set storage rack with 3 screws front and 3 screws back.
Remember to attach the ground strap at the middle screw on the rear (belt
© Copyright 2009 GBC. All rights reserved.
PAPER EXIT
SIDE
Advanced Punch Service Manual