Punch Module Brake Replacement And Adjustment; Punch Module Brake Replacement - GBC AdvancedPunch Technical & Service Manual

Section 4

4.9.4 Punch Module Brake Replacement and Adjustment

4.9.4.1 Punch Module Brake Replacement

4-60
Procedure
Remove the Punch Module Assembly first, using procedure
Removal" on page 4-49.
To replace the brake, first remove the clutch and related drives. See
Replacement" on page 4-55. The brake must be adjusted while on drive shaft. To
adjust the brake, see "Punch Module Brake Adjustment"
Tools Needed
•
Feeler gage, 0.010" (0.25 mm)
•
Hex wrenches, 0.05" and 3/32"
•
Flat blade screwdriver
•
Pliers
To replace the brake:
1. Remove the 4 socket head set screws [1].
2. Loosen the 2 set screws [2] until the brake pad [3] slides freely on the shaft.
[1]
Figure 4.68 Brake Assembly and Drive Shaft.
Installation Note: When installing the brake, ensure that the 2 set screws
engage the flats on the shaft. To adjust the brake, see
Adjustment" on page 4-62.
© Copyright 2009 GBC. All rights reserved.
[3]
[2]
Advanced Punch Service Manual
"Punch Module
"Clutch
on page 4-62.
"Punch Module Brake