GBC AdvancedPunch Technical & Service Manual page 87

Advanced Punch Service Manual
Figure 4.29 Removing the Aligner Drive Belt.
Caution: As you do this, disconnect the sensor harness behind the assembly as soon as
you are able to reach it. Failure to do this can damage the unit.
5. Remove the green drive belt Aligner Roller assembly by removing the 4 screws
(S).
Caution: Leave the Flex Shaft (FS) attached.
6. Remove the green drive belt Aligner Roller assembly by removing the 4
screws.
Caution: Leave the Coupler attached.
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
ALIGNER DRIVE
BELT ASSY
4-29