Removing The Rear Cover - GBC AdvancedPunch Technical & Service Manual

Section 4

4.1.2 Removing the Rear Cover

4-2
Separate the punch from the printer and finisher first. Refer to "Separating
thePunch From the Printer" in Section 4.1.
Note: It is not necessary nor recommended that you remove the top cover.
Procedure
Tool Required
•
Phillips screwdriver or 1/4" hex head nut driver
To remove the rear cover:
1. Remove the 5 screws on the entrance side [1] & remove the 4 rear cover
screws [2]
2. Slide the cover out from under the top cover. Do not remove the top cover.
[2]
© Copyright 2009 GBC. All rights reserved.
[1]
Figure 4.1 Removing Rear Cover.
Advanced Punch Service Manual