Final Service Action - GBC AdvancedPunch Technical & Service Manual

Section 1

1.5 Final Service Action

1-32
This section explains the actions a technician should take at the end of every
service call. With each step, verify that the system runs smoothly and paper jam
free.
1. Inspect each Die Set visually and lubrication as needed. See
on page 1-8.
2. Using the customer's primary Die Set pattern, run 200 simplex printed test
sheets through the punch mode and examine the output for clean hole quality
and even hole alignment.
3. Using the customer's primary Die Set pattern, run 200 duplex printed test
sheets through the punch mode and examine the output for clean hole quality
and even hole alignment.
4. Using any of the customer's secondary Die Set pattern, run 100 simplex
printed test sheets through the punch mode and examine the output for clean
hole quality and even hole alignment.
5. Run 100 sheets simplex and 100 sheets duplex through the punch bypass
mode.
6. Clean out all paper chips (chad) and paper dust from the chip tray, the bottom
of the machine and from the floor around the bottom of the machine. See
Cleaning on page 1-12.
7. Explain to the customer the service work that was performed and ensure they
are satisfied before you close the call.
© Copyright 2009 GBC. All rights reserved.
Die Set Service
Advanced Punch Service Manual
Base