GBC AdvancedPunch Technical & Service Manual page 62

Section 4
4-4
3. Loosen the locking nut [1] of the castor.
[1]
4. From below the frame and at the top of the castor [2], adjust the height of the
castor as needed.
5. Check the level and adjust as necessary.
6. Tighten the locking nut [1].
7. Ensure punch is level and in line with printer and finisher.
8. Replace rear cover.
© Copyright 2009 GBC. All rights reserved.
Figure 4.3 Castors Locking Nuts.
Advanced Punch Service Manual
[1]