GBC AdvancedPunch Technical & Service Manual page 130

Section 4
ADJUSTMENT
SCREW
4-72
LOCK-DOWN
SCREW
Figure 4.84Die Set Position Cradle Adjustment
4. Before you adjust the die set position cradle, you must loosen the lock-down
screw.
5. Using a flat-blade screwdriver, turn the adjustment screw clockwise or counter-
clockwise to move the die set position cradle.
ADJUSTMENT
SCREW
Figure 4.85 Adjusting Die Set Position.
© Copyright 2009 GBC. All rights reserved.
PRESS HERE TO
TILT
LOCK-DOWN
SCREW
Advanced Punch Service Manual
PRESS HERE
TO TILT