GBC AdvancedPunch Technical & Service Manual page 135

Advanced Punch Service Manual
aligner panel as per
assembly)
4. Remove the screw [1] and nut [2] that secure the sensor to the sheet metal
part.
[2]
[1]
Figure 4.93 Sensor S2 Replacement
[1]
[2]
Figure 4.94 Sensor S6 Replacement
•
Replacement of sensor S4 and S5 (See below image)
1. Remove the rear cover as per Sec
2. Remove the punch module as per Sec
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
4.6.3.4 (Exclude last step of removing green drive belt
4.1.2
4.9.1
4-77