Punch Drive Cam Lubrication - GBC AdvancedPunch Technical & Service Manual

Section 4

4.9.2 Punch Drive Cam Lubrication

4-54
Maintenance Schedule
Lubricate every 750K cycles with Teflon grease.
Procedure
The Punch Drive module must be removed for service. Clean the old grease from the cams
and then apply a light coat of high quality grease (not oil). To remove the module, see
"Punch Module Removal"
Installation Note: Make sure the wires on the rear of the punch are not
obstructing the Die Set or Chip Bin.
© Copyright 2009 GBC. All rights reserved.
on page 4-49.
Grease cams
Figure 4.59
Advanced Punch Service Manual