Section 4
4.6.3.3 Entrance Aligner Panel Installation
4-26
To install the Idler Aligner panel, refer to
Cleaning"
on page 1-20. Then insert the punch into the printer and finisher and
connect the power cord.
Test the Advanced Punch by doing the following:
1. Run10 copies in bypass mode.
2. Run 1 sheet in punch mode.
3. Run 10 sheets in punch mode.
4. Run 100 sheets in punch mode.
© Copyright 2009 GBC. All rights reserved.
"Back Gauge Solenoid Inspection and
Figure 4.26 Removing Rear Aligner.
Advanced Punch Service Manual
AFTER ASSEMBLY