Aligner Panel Inspection And Cleaning - GBC AdvancedPunch Technical & Service Manual

1.4.10 Aligner Panel Inspection and Cleaning

Advanced Punch Service Manual
Maintenance Schedule
Clean every 750K cycles.
Procedure
Inspect for worn or damaged parts. Clean with alcohol, an approved cleaner, or a
soft cloth moistened with mild detergent and warm water as needed.
To clean the Aligner Panels:
1. Lift the Aligner latches to open panels.
2. Clean surfaces [1].
3. Clean paper alignment channels [2].
[1]
[2]
Figure 1.11 Aligner Panel Components.
© Copyright 2009 GBC. All rights reserved.
Maintenance
1-15