Punch Module Brake Adjustment - GBC AdvancedPunch Technical & Service Manual

Section 4

4.9.4.2 Punch Module Brake Adjustment

4-62
Procedure
The brake can be adjusted without removing the brake from the shaft. The gap
between the brake and the pad is 0.010" (0.25 mm)
To adjust the brake:
1. Loosen the 2 set screws [2] until the brake pad slides freely on the shaft.
0.010"
Figure 4.70 Brake Assembly Gap Adjustment.
2. Use a 0.010" feeler gage to set the gap between the brake and the brake pad.
3. Tighten the 2 set screws and check the gap.
© Copyright 2009 GBC. All rights reserved.
[1]
Advanced Punch Service Manual