Clutch Replacement - GBC AdvancedPunch Technical & Service Manual

4.9.3 Clutch Replacement

Advanced Punch Service Manual
Procedure
Replace if clutch is malfunctioning.
Note: The clutch can be removed without removing the Punch Module.
Tools Required
•
Phillips screwdriver or 1/4" nut driver
•
Hex wrench, 5/64"
To remove the clutch:
1. Unplug the flag sensor connector [1].
[1]
Figure 4.60 Flag Sensor Connector on Rear of the Punch.
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
4-55