GBC AdvancedPunch Technical & Service Manual page 214

8. PUNCH CONTAINER
The Punch Container for your AdvancedPunch is located at the front
of the machine's base. The drawer should periodically be pulled out
and emptied. The AdvancedPunch uses a sensor to determine when
the punch container is full. Once the punch container becomes full
the LED light on the front panel of the AdvancedPunch will illuminate
and a message will appear on the printers user interface screen.
9. PROBLEM SOLVING
Probable Cause
No power, won't punch
Die Set will not come out using
a moderate pull
Fault Codes
Fault codes for the AdvancedPunch are displayed on the machine's UI
as an AdvancedPunch fault code. Listed below are fault codes that
apply specifically to the AdvancedPunch product.
Fault
Possible Cause
Code
040-100 Jam is detected in
040-101 AdvancedPunch.
040-900
040-901
040-300 Front door of
AdvancePunch is not
closed.
040-940 Dieset is missing or not
fully installed.
040-941 Punch container is
mising or not fully
installed
040-942 Punch container is full.
140-700 Punch container is
near full.
Advanced Punch Service Manual
Probable Cause
Power cord not attached to back of
machine or not properly plugged into
the wall Power On/Off Switch not
activated
The Die Set is in partial cycle. Turn
the Die Set knob (J3) to the HOME
position. Home position is when the
arrows line up. The Die Set should
now slide out easily.
Also see Paper Jams.
Recommended Solution
Open front door and
inspect for paper jam.
Remove papaerjam if found,
then close front door.
Close front door of
AdvancedPunch.
Install dieset or fully insert
dieset, then close front door.
Install and/or fully insert
punch container, then close
front door.
Empty punch container and
then re-install.
Empty punch container and
then re-install.
© Copyright 2009 GBC. All rights reserved.
AdvancedPunch
10. SPECIFICATIONS
115V Machines
Speed Up to 127 sheets per minute
Punch Sheet Size Letter - 8.5" x 11"
Punch Edge 11"
Paper Stock 20# bond to 80# cover
Paper Bypass Mode Paper sizes and stocks same as
Sheet size printer
Punch Capacity Single Sheet
Power Supply
115V, 60 Hz,
Single Phase
Electrical
BTUs/Hour
Watts
Amps
Safety
TUV/GS, CE
Dimensions
12" (30.5cm) (W) x 38.5" (97.8cm)
(H) x 28.5" (72.3cm) (D)
Weight
154 lbs. (70 Kg)
Shipping Weight
254 lbs. (115.5 Kg)
Manufactured Assembled in Taiwan
Installation and Set Up
GB
1057BTU/HR
310W
2.8A
8-19