8.3 Unpacking
8.4 Test Operation
Advanced Punch Service Manual
•
Inspect the outside of the package for shipping damage. If there is evidence of
shipping damage, contact the shipping carrier immediately.
•
Remove the punch from its shipping carton.
•
Inspect for any concealed damage to unit. If there is evidence of concealed
shipping damage, contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
•
Check to ensure that the paper chip tray is securely in place.
•
Check to ensure that a Die Set is installed properly and that any extra Die
Sets are securely stored in the Die Storage Area.
•
Run a small test job in Bypass mode. Check to ensure that the job is not
punched and bypasses properly.
•
Run a small job with Punch Enabled. Check the punched holes of the job.
•
Ensure the paper output is stacking properly.
•
Ensure the hole quality of the sheet output is proper
© Copyright 2009 GBC. All rights reserved.
Installation and Set Up
8-11