Punch Module Motor Replacement - GBC AdvancedPunch Technical & Service Manual

4.9.5 Punch Module Motor Replacement

Advanced Punch Service Manual
Procedure
Replace motor when it malfunctions.
To replace the Punch Module motor:
1. Cut any wire ties as necessary to release the motor wires.
2. Unplug motor wire connections from the capacitor [1].
3. Remove the metal spring clip [1] from the fan and slide the fan [2] off the shaft.
[1]
Figure 4.72 Punch Fan and Spring Clip.
Installation Note: When installing the fan, be sure to align the flat of the fan hub
with the flat on the shaft. Also, make sure the hub and spring clip are facing away
from the motor.
© Copyright 2009 GBC. All rights reserved.
Repair and Adjustment Procedures
Figure 4.71 Punch Capacitor.
[3]
[2]
4-63