Hole Alignment Adjustment - GBC AdvancedPunch Technical & Service Manual

Section 4

4.11Hole Alignment Adjustment

4-70
2. Remove the belts in order as shown in
[2]
[5]
[1]
3. To install and adjust the tension of the belts, reverse these steps.
Die Set Position Cradle Adjustment, The die set position cradle is set in the
factory; however, because of the punched-hole spacing on the PB die sets, there
is a minimal amount of paper on each edge of the punched paper. The die set
position cradle may have to be fine adjusted to center the punched-hole pattern in
the paper.
Listed below are the step-by-step instructions to adjust the die set to the proper
position.
1. The punched-hole alignment must be checked on a piece of punched paper.
Fold the punched sheet of paper in half and the punched-holes should be
aligned. If the punched-holes are not aligned, then the die set cradle must be
adjusted to align the punched holes.
Note: The paper path is always constant, if the holes are not centered, you must
adjust the die set cradle.
© Copyright 2009 GBC. All rights reserved.
Figure
Figure 4.81 Order of Belt Removal.
Advanced Punch Service Manual
4.81.
[1]
[3]